[embedit snippet=”gas-468×60″]
After coming back from fishing one morning I was annoyed when trying to find room in the corner of my garage for my rods, or trying to make room to cram them on a shelf. I happened to have some 2×4’s, a saw, drill and screws so rather than going out to spend money at a store to fix my problem, I used what I had and in not very long I had exactly what I needed for all my fishing rods and ice auger! This simple fishing rod rack & organizer can be made however wide or short needed to fit all your fishing rods and ice auger too. Check it out …
Materials:
- 3 2×4’s (length equal to how wide you would like to built the unit)
- Saw
- Drill (with 1 1/2″ wood bit & screw driver attachments)
- 3″ Wood Screws
- Wood Stain / Varnish
- PPE (Safety Glasses, Work Gloves, Hearing Protection, Etc.)
Instructions (for a 30″ wide unit):
1) Cut 3 2x4s at 30 inches …….
[embedit snippet=”gas-468×60″]
2) Mark out and drill 10 1.5 inch holes evenly apart in 2 of the 2x4s …….
3) Sand it all and stain it ……..
4) Put two 3 inch screws in the top and bottom with the 3rd 2×4 in the middle as show in the picture below …….
[embedit snippet=”gas-auto-responsive-link-ad-minimalist”]
5) That’s it you’re done …….
To secure the rod rack to the wall, locate 2 studs and fasten the rack to them with the 3″ screws … one screw per stud should be enough but use as many as you need to ensure that it is secure.
That’s it … now go ahead and load up the rod rack with your fishing poles and ice auger and say good bye to rod clutter frustration forever!
*** Don’t have the time, space, tools or desire to build one of these yourself but could really use one? No problem! To purchase a pre made, ready to install fishing rod rack organizer for only $20.00 contact me anytime! 🙂
Like our stuff? Subscribe by 
Feed or 
Email .jpg)
